Specifications

SeriaLynx Specifications

Spec Sheet page 1

Spec Sheet Page 2

Zipped PDF Specsheet

ITEM

SPECIFICATION

Ethernet

Complies with 802.3 (Ethernet) and 802.11b standards; uses DSSS Technology

Wired data speed

10Mbps

Wireless data speed

Up to 11Mbps

Frequency Band

2400-2483.5 MHz

Operating Channels

US, Canada: 11 channels

Roaming

IEEE 802.11b compliant

Indoor range

100-300 ft

Outdoor range

Up to 1000 ft dependent on conditions and data speed.

Power Supply (Battery)

Built-in rechargeable NiMH batteries

Charging/Operating Voltage

12-24V DC 1.2A

Charging Time

Approximately 2.5 hours (from full battery depletion)

Battery Life (Wired)

Approximately 7 hours (depending on activity level)

Battery Life (Wireless)

Approximately 4-6 hours (depending on activity level)

LED MAP

LED NAME		DESCRIPTION
b. Power mode indicator		Green = external power applied
b. Power mode indicator		Amber = battery power applied
c. Battery mode indicator		Solid green = battery in use
		Blinking green = battery low (approximately 20 minutes remain)
		Solid Amber = battery fully charged
		Blinking Amber = battery charging
		Solid red = battery failure
d. Status indicator		Solid Green = unit in normal mode
		Solid Amber = unit in config mode
		Solid Red = unit error
e. COM1 activity indicator		Green: Network connection (socket) established on this serial port
		Blinking Green: In PPP or SLIP Mode, remote end has not yet established the connection; In "Connect To" Mode, not connected yet.
		Blinking Amber = serial port 1 is receiving
		Red: Serial port receive error (parity, overrun, etc)
		Blinking Red: Serial port receive buffer full (due to the network connection not accepting the incoming data fast enough)
		Amber: Serial port activity (RX or TX)
		Off: Not in PPP or SLIP mode and no network connection made
g. COM2 activity indicator		Green: Network connection (socket) established on this serial port
		Blinking Green: In PPP or SLIP Mode, remote end has not yet established the connection; In "Connect To" Mode, not connected yet.
		Blinking Amber = serial port 2 is receiving
		Red: Serial port receive error (parity, overrun, etc)
		Blinking Red: Serial port receive buffer full (due to the network connection not accepting the incoming data fast enough)
		Amber: Serial port activity (RX or TX)
		Off: Not in PPP or SLIP mode and no network connection made
f. Wired Ethernet link/activity indicator		Green = Ethernet link active
		Blinking green = NIC on but not connected
		Blinking Amber = Ethernet receiving
		Red = collision
		Off: NIC not in use
h. Radio link/activity indicator		Green: Link Ok (ie, connected)
		Blinking Green: NIC on but not connected
		Red: Collision
		Amber: Activity (RX or TX)
		Blinking Amber: NIC asleep
		Off: NIC not in use

Lynx System Developers, Inc